Savotta Valjas Slim Belt Pad (Färg: Multicam, Storlek: Medium - Large)

A slim belt pad for common 45-50 mm wide belts. Low-profile and padded enough to comfortably carry relatively light loads. Friction lining to prevent unwanted sliding around. Two layers of dense 4 mm cell foam padding Body-side rubberized friction fabric Flat 60 mm wide belt loops with 25 mm spacing Belt loops also enable horizontal attachment of PALS pouches Three size options available (S-M, M-L, L-XL) All colour options offer good NIR performance 5 year material and workmanship warranty Made in Finland/Estonia This is pretty much as simple as a belt pad can be and works with pretty much any belt that fits. The flat belt loops, made from 25 mm webbing, are 60 mm wide. As these are attached with 25 mm spacing they can be used to attach PALS-compatible pouches horizontally. The padding is two layers of 4 mm thick dense closed cell foam. The body side is made from rubberized friction fabric, it keeps the padded belt from sliding up and down and all around. Check out the 3-piece belt pad of our Valjas belt system if you’re looking to carry a heavier belt kit. The larger, wider pads allow for more carrying comfort and feature dedicated harness attachment D-rings. Fit and sizing The ”S-M”, ”M-L” and ”L-XL” sizing should be considered a rough guideline! The S-M pad is 70 cm (27,5”) long, the M-L pad is 80 cm (31,5”) long and the L-XL pad is 95 (37,5”) cm long. These work best with a 15-30 cm (6-12”) gap in between the pad ends at the front. To find your size: Get dressed as you would be when using your padded belt, trouser belt and all Measure your circumference at the height where you want to wear your padded belt, most commonly this is just above your hips Say that measurement is 100 cm (40”), a S-M pad would leave a full 30 cm (12”) gap at the front, whilst a M-L would leave a 20 cm (8”) gap at the front. In this case we recommend going with the M-L